Gas membrane building | double inflatable membrane Greenhouse lock "German film structure" and Germany has more than 100 customers to solve cesspool stamped, servo technologies lead the industry! A supporting structure and anchor design, film, cable may be too end member connected to the plate and the mast connection, the following figure shows several common node configuration schematic top of the mast. Second, the connection and the connection cable with the membrane and the mast mast should not be in the same spot, caused by the eccentricity should be considered in the design. Third, the cable support node can be used depending on the type of the support structure of the following form: Four, cable and reinforced concrete structures or steel member connections should adopt a flexible material or the use of structural measures to protect cables, so as not to damage or bend the cable. (5) When the cable is connected with the position of the boundary of the film is inconsistent, it should be considered in the design of additional internal forces generated on the edge member. Sixth, the support structure should refer to the relevant specifications for strength, rigidity design, and should be checking the stability of the membrane surface in case of sudden localized damage to the structure. Seven, cable anchoring system should be selected according to the durability of gravity, the surface of the construction site, infrastructure and soil conditions and other specific circumstances, plate resistance, mushroom resistance, resistance wall, pulling piles, friction and other types, see below. Eight pullout capacity cable anchoring system should be based on the type of anchoring system, ground conditions, and other factors to determine the age, and shall be subject to on-site investigation and soil tests to determine the pullout strength. www.zdmjg.com